IndyCar
07 May
-
09 May
Next event in
48 days
22 May
-
24 May
Next event in
63 days
29 May
-
31 May
Next event in
70 days
R
Texas
04 Jun
-
06 Jun
Next event in
76 days
R
Road America
19 Jun
-
21 Jun
Next event in
91 days
25 Jun
-
27 Jun
Next event in
97 days
R
Toronto
10 Jul
-
12 Jul
Next event in
112 days
R
16 Jul
-
18 Jul
Next event in
118 days
R
Mid-Ohio
14 Aug
-
16 Aug
Next event in
147 days
R
Gateway
20 Aug
-
22 Aug
Next event in
153 days
R
Portland
04 Sep
-
06 Sep
Next event in
168 days
R
Laguna Seca
18 Sep
-
20 Sep
Next event in
182 days

Aeroscreen prompts updated IndyCar pitstop, equipment regs

shares
comments
Aeroscreen prompts updated IndyCar pitstop, equipment regs
By:
Feb 26, 2020, 9:48 PM

The introduction of the Red Bull Advance Technologies-developed aeroscreen in 2020 has prompted the NTT IndyCar Series to allow an extra team crew-member over the wall in a pitstop, to act purely as an aeroscreen attendant.

That means there will be seven crew members per car allowed on pitlane during a pitstop – four tire changers, one airjack operator, one fueler, and one aeroscreen attendant. 

The rule stipulates that the attendant may only work on the aeroscreen and its tear-offs, and must remain in control of all tear-off materials.

This “seventh member” must remain behind pit wall until the car comes to an absolute stop, and may only work while the car’s rear tires are in the air. 

Driver wariness regarding the amount of air that reaches the cockpit since the aeroscreen’s installation has also prompted fresh stipulations from IndyCar. Helmet ducting will be mandatory at all road, street and short-oval tracks, but is not allowed for the Indy 500 nor Texas 600. The helmet manufacturer will provide the attachment but the ducting hose can only be attached with a quick disconnect system approved by IndyCar.

Nose inlet cooling is mandatory for road, street and short-oval tracks and again is not permitted at IMS and TMS. The tubes may not extend past the rearward face of the bulkhead but may have filtration added as long as it is contained within the tubes, and the tube inlets may be sealed using tape or a cover provided there is no change to the intended shape.

The front duct exit port, optional at all events, must remain open on the bottom, but may be trimmed to change or direct the airflow.

IndyCar has also stated in the regulations that additional fasteners for the aeroscreen and that all components must be used as supplied. Ergo nothing may be added between the two mounting surfaces, and the frame may not be fitted to the carbon top plate.

Regarding pitlane safety, while the pit speed limits for superspeedways and speedways remains 60mph, the limits on road courses, street circuits, and short ovals has been reduced from 2019’s setting of 50mph to 45mph in 2020. The exception is the Honda Indy Toronto which, due to the tortuous nature of its pitlane, will have its limit set at only 40mph.

Jack Harvey, Meyer Shank Racing Honda

Jack Harvey, Meyer Shank Racing Honda

Additional reporting - TrackSide Online

Related video

Next article
Alonso open to other IndyCar races besides Indy 500

Previous article

Alonso open to other IndyCar races besides Indy 500

Next article

Citrone/Buhl confirms RLL partnership, Pigot as driver

Citrone/Buhl confirms RLL partnership, Pigot as driver
Load comments

About this article

Series IndyCar
Author David Malsher-Lopez